Complete the crossword, then click on "Check" to check your answer. If you are stuck, you can click on "Hint" to get a free letter. Click on a number in the grid to see the clue or clues for that number.
These lathes are operated with complete automatic control.
5.
A set of two small gears are placed just below the spindle gear and connected to the spindle gear in the lathe.
6.
Work pieces of short length, large diameter and irregular shapes, which cannot be mounted between centres, are held quickly and rigidly in
7.
placed parallel to the leadscrew infront side of the bed.
8.
mounted on the compound slide. It is used for holding the cutting tool tightly.
9.
It is a process of enlarging the diameter if done internally and reducing the diameter if done externally over a short length.
Down:
1.
It is attached to the carriage and hangs over the front side of the lathe bed.
2.
It has similar features of an engine lathe but is accurately built and has wide range of spindle speeds to perform precise operations and different feeds.